Mode Selection for the TM-m30
Here you will find instructions on how to perform the mode selection on the TM-m30:
- Press the power button and then immediately hold down the feed button.
- Hold the Feed button again to access the Mode settings.
- Now press the Feed button 14 times and hold the Feed button the 15th time to get to the option 14. Interface Settings .
- Now press eight times the feed button and hold at the Feed button at the 9th press for a few seconds to get to the Main connection interface option.
- Now the setting is Auto. You can see this by the * (asterisk).
Connection via USB
Press the feed button twice briefly and hold it down the third time
Connection via Bluetooth
Press the feed button 3 times briefly and hold it down the 4th time
Connection via Ethernet
Press the feed button 4 times briefly and hold it down the 5th time
- To exit, press the Feed button once briefly and hold it a second time for more than one second.
The printer is now fully configured.
Turn the printer off and then back on. If necessary, you can also run a self-test again. This time, the interface you want to use to connect to your device should be selected.
If you made a mistake, turn the printer off again and start again from step 1.
